XCMG TZ3 Three-boom hydraulic rock drill jumbo Drill Jambo
Product Feature
• Rock drill: hydraulic rock drill is designed with special structural process on the basis of the tunneling construction process in China, being characterized by super-strong deflection resistance capacity, high drilling speed and low drilling tool exhaustion, capable of effectively improving the use performance of the tunnel side hole operation.
• Booster: lightweight high-strength alloy beam, high-strength, flexural resistant, torque resistant and fatigue performance, longer service life.
• Chassis: energy-efficient, environment-friendly and low-discharge engine with strong power, all-terrain and full-driven adaptive walk system; whole vehicle frame, rear wheel steering, and good vehicle stability.
• Drill arm: the proprietary technology is used for full-sided parallel holding of the drill arm, with accurate positioning; the drill arm is designed with equal strength, characterized by reasonable structure, high strength and long service life.
• Drilling system: designed with the automatic rod jamming, idle drilling prevention and automatic rod retrieval functions, capable of effectively improving the drilling efficiency.
Product Parameter
Operation performance parameter | Unit | TZ3 |
---|---|---|
Maximum operation coverage area | m² | 180 |
Maximum operation height | mm | 13075 |
Maximum operation width | mm | 15725 |
Drill arm extension length | mm | 1600 |
Drill arm lifting angle | ° | 70/-30 |
Drill arm swing angle | ° | ±45 |
Propeller overturning angle | ° | 360 |
Propeller compensation length | mm | 1800 |
Maximum pushing force | kN | 20 |
Borehole depth | mm | 5140 |
Rock drill impact power | kW | 17/20 |
Rock drill impact frequency | Hz | 60/70 |
Rock drill turning torque | N.m | 325/762 |
Borehole diameter | mm | 45/70 |
Work service platform | Yes | |
Cabin roof lifting height | mm | 700 |
Lift of the flushing pump | m | 153 |
Flow of flushing water | L/min | 300 |
Water inlet pipe diameter/length | "/m | 2/80 |
Pressure of air lubricating system | bar | 3/8 |
Maximum air lubricating amount | L/min | 1050 |
Electrical system parameters | ||
Total installed power | kW | 200 |
External power supply | V/Hz | 380/50 |
External cable length | m | 100 |
Quantity of main pump motor | 3 | |
Power of main pump motor | kW | 55 |
Rotating speed of main pump motor | r/min | 1470 |
Power of pump motor | kW | 11 |
Transformer power | kW | 7.5 |
Main work lighting | kW | 0.4×2 |
Auxiliary work lighting | kW | 0.15×2 |
Drive performance parameters | ||
Maximum drive speed | km/h | 17.5 |
Drive means | 4×4 | |
Maximum gradability | % | 25 |
Minimum turning radius | m | 5.5 |
Turning mode | Independent steering of rear axle | |
Turning angle | ° | 29.5/-37 |
Service brake | Hydraulic two-circuit, wet-type | |
Parking brake | Disc-type, hydraulic relief | |
Minimum ground clearance | mm | 230 |
Approach angle/departure angle | ° | 15.5/15 |
Engine | ||
Engine model | Deutz TCD2013 L06 2V | |
Power/rotating speed | kW/r/min | 200/2300 |
Discharge | Non-road, Euro III | |
Mass parameters | ||
Vehicle mass | kg | 45800 |
Size parameters | ||
Outline dimensions (L*W*H) | mm | 16000×2950×3400 |